ZDOD240PSS – GE Monogram Stainless Steel Outdoor/Indoor Refrigerator Module
Dimensions and Specifications (in inches)
Installation Space
Product Clearances
Locate Outlet
24"
Cabinet
10-1/2"
24" Min.
9"
Max.
34-1/2" Min.
1-1/2"
23-3/4" Min.
23-3/4"
110˚
Note: Handle and
handle standoff
depth is 2-3/4"
34-1/2"
15" Minimum
(36"with
top
All models are factory set for a 110° door swing.
26-1/2"
Including
Handle
canopy)
For a minimum 90° door swing:
• Allow 5-1/4" min. clearance to wall on the hinge side.
For a full 110° door swing:
23-3/4"
• Allow 15" min. clearance to wall on the hinge side.
Note: If installing between frameless cabinets, a 1/2" wide filler
strip or side panel may be required. The filler strip will act as a
spacer between the door case and adjacent cabinet and will prevent
interference with cabinet door swing. The width of the opening must
include filler panels.
Note: This product can be installed as a built-in or used free-standing.
The top canopy can be removed for installation below a countertop.
The cutout depth must be 24"
The cutout dimensions shown allows for a full door swing and access
to the pull-out racks when installed as a built-in.
• The outdoor/indoor refrigerator can be used freestanding.
• Stainless steel top canopy can be removed for built-in installation.
• Vented stainless steel toekick.
Additional Specifications:
• A 120 volt 60Hz., 15 or 20 amp power supply is required.
An individual property grounded branch circuit or circuit breaker
is recommended. Install a properly grounded 3-prong electrical
receptacle recessed into the back wall as shown. Electrical must
be located on rear wall as shown.
Listed by
Underwriters
Laboratories
Warning:
R
This product must be connected to a power source with Ground
Fault Circuit Interrupter (GFCI) protection when installed in an
outdoor location.
For answers to your Monogram, GE Profile™ or
GE® appliance questions, visit our website at
GEAppliances.com or call GE Answer Center®
service, 800.626.2000.
®
Specification Revised 7/05
120028
ZDOD240PSS – GE Monogram Stainless Steel Outdoor/Indoor Refrigerator Module
Features and Benefits
• Stainless steel outdoor design – Sturdy, professional
grade exterior stands up to the most demanding
environmental conditions
• Electronic adjustable temperature control –Offers a range
of temperatures for precise chilling
• LED temperature display – Allows you to monitor the
temperature at a glance
• Removable spillproof glass shelves – Helps contain spills
for ease of cleaning
• QuickSpace™ Shelf – Quickly slides out of the way to make
room for tall items
• Two beverage shelves on full-extension slides – Each
holds up to five wine bottles or ten 12-oz. cans
• Stainless steel removable canopy – Canopy protects the
top of the refrigerator in outdoor environments and can be
removed to allow built-in installation
• Stainless Steel – Conveys a look of utmost polish
and sophistication
• Professional-style handle – Coordinates with other
Monogram Professional cooking appliances
• Model ZDOD240PSS – Stainless steel
• Model ZDOD240PLSS – Stainless steel, left hinge
Specification Revised 7/05
120028
|
Dyson Vacuum Cleaner DC31 User Manual
Echo Trimmer SRM 2100 2110 User Manual
Edimax Technology Network Card Edimax Wireless LAN Cardbus Adapter User Manual
Eizo Computer Monitor F520 User Manual
Franke Consumer Products Coffeemaker 471086A1 User Manual
Frigidaire Microwave Oven 316495063 User Manual
Frigidaire Washer Dryer 137339000A User Manual
Fujitsu Cell Phone Accessories MB3891 User Manual
Fujitsu Laptop P5020 User Manual
GE Water Heater AP13204 4 User Manual